Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO ANTENNA CORD

RADIO ANTENNA CORD > REMOVAL

for Preparation Click here



1. REMOVE UPPER INSTRUMENT PANEL ASSEMBLY

HINT:
Refer to the procedure up to Remove Upper Instrument Panel Assembly (Click here).



2. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY (for LHD)


  1. for Connector Type Antenna Cord:



      E188520
    1. Disconnect the connector.

    2. Remove the bolt.

    3. Disengage the 4 clamps and remove the No. 2 antenna cord sub-assembly.



  1. for Plug Type Antenna Cord:



      E188518
    1. Disconnect the 2 connectors.

    2. Remove the bolt.

    3. Disengage the 5 clamps and remove the No. 2 antenna cord sub-assembly.



3. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY (for RHD)


  1. for Connector Type Antenna Cord:



      E188521
    1. Disconnect the connector.

    2. Remove the bolt.

    3. Disengage the 5 clamps and remove the No. 2 antenna cord sub-assembly.



  1. for Plug Type Antenna Cord:



      E188523
    1. Disconnect the 2 connectors.

    2. Remove the bolt.

    3. Disengage the 6 clamps and remove the No. 2 antenna cord sub-assembly.



4. REMOVE ROOF HEADLINING ASSEMBLY

HINT:
Refer to the procedure up to Remove Roof Headlining Assembly (Click here).



5. REMOVE NO. 2 ROOF SILENCER PAD (w/o Sliding Roof)


  1. Remove the No. 2 roof silencer pad from the roof headlining assembly.


    B228248



6. REMOVE NO. 3 ROOF SILENCER PAD (w/o Sliding Roof)


  1. Remove the No. 3 roof silencer pad from the roof headlining assembly.


    B228252



7. REMOVE NO. 4 ANTENNA CORD SUB-ASSEMBLY


  1. Peel the strips of the tape used to secure the antenna cord only to the extent that allows removal of the antenna cord.


    E191249E01

  1. Remove the No. 4 antenna cord sub-assembly.



8. REMOVE NO. 5 ANTENNA CORD SUB-ASSEMBLY


    E188491
  1. Disconnect the 2 connectors.

  1. Remove the bolt.

  1. Disengage the 4 clamps and remove the No. 5 antenna cord sub-assembly.