Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › ULTRASONIC SENSOR

ULTRASONIC SENSOR > REMOVAL

for Preparation Click here



1. REMOVE RADIATOR SUPPORT OPENING COVER


    B228429
  1. Remove the 3 clips.

  1. Disengage the 2 claws and remove the radiator support opening cover.



2. REMOVE FRONT BUMPER ASSEMBLY


    B228430E01
  1. Put protective tape around the front bumper assembly.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    Use the same procedure for the RH side and LH side.



    B228431
  1. Using a screwdriver, turn the pins 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.



    B228433
  1. Remove the screw.

    HINT:
    Use the same procedure for the RH side and LH side.



    B228434
  1. Remove the 2 bolts and 4 screws.

  1. Using a clip remover, remove the 7 clips.



    B228436
  1. Using a clip remover, remove the 2 clips. (w/ Front Spoiler)

  1. Remove the 2 screws. (w/ Front Spoiler)

  1. Disengage the 2 guides and remove the front spoiler cover. (w/ Front Spoiler)



    B228439
  1. Disengage the 3 claws and remove the front bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Disconnect each connector.

  1. Disconnect the headlight cleaner hose and drain the washer fluid. (w/ Headlight Cleaner System)

    HINT:
    Use a container to collect the washer fluid.



    B228441
  1. Remove the front bumper assembly as shown in the illustration.



3. REMOVE NO. 1 ULTRASONIC SENSOR


    E189837
  1. Disconnect the connector.

  1. Disengage the 4 claws and disconnect the wire harness with bracket.



    E189838
  1. Disengage the 2 claws and remove the No. 1 ultrasonic sensor.

    HINT:
    Use the same procedure for the RH side and LH side.



4. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER


    E189840
  1. Disengage the 2 claws and remove the No. 1 ultrasonic sensor retainer.

    HINT:
    Use the same procedure for the RH side and LH side.