Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST ECU

PARKING ASSIST ECU > INSTALLATION

for Preparation Click here



1. INSTALL PARKING ASSIST ECU (for RHD)


    E189831
  1. Engage the claws to install the parking assist ECU.

  1. Install the nut.

    Torque:
    14 N*m{ 138 kgf*cm , 10 ft.*lbf }



2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY (for RHD)
  1. Connect each connector.

  1. Engage the clamp.

  1. Engage the 2 guides and claw to connect the hood lock control cable.



    B298864
  1. Engage the 6 claws and clip.

  1. Install the lower instrument panel finish panel assembly with the screw <C>.



3. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH (for RHD)

HINT:
Use the same procedure described for the LH side .



4. INSTALL FRONT DOOR SCUFF PLATE RH (for RHD)

HINT:
Use the same procedure described for the LH side .



5. INSTALL PARKING ASSIST ECU (for LHD)


    E189832
  1. Engage the claws to install the parking assist ECU.

  1. Install the nut.

    Torque:
    14 N*m{ 138 kgf*cm , 10 ft.*lbf }



6. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY (for LHD)


    B223650E01
  1. With the glove compartment door assembly opened approximately 55° from its closed position, engage the 2 hinges horizontally.
    Text in Illustration 
    *a
    Opened Approximately 55°
    *b
    Closed

    NOTICE:
    Engaging the hinges from the top will deform the hinges. Be sure to install the glove compartment door assembly horizontally.



    B223648E01
  1. Slightly bend the stoppers (A) and (B) in the directions indicated by the arrows in the illustration and engage the stoppers to install the glove compartment door assembly.
    Text in Illustration 
    *1
    Glove Compartment Door Stopper Sub-assembly
    *2
    Stopper

  1. Engage the claw and connect the glove compartment door stopper sub-assembly.



7. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)
  1. Connect the connector.

  1. Engage the guide and 3 claws to install the No. 2 instrument panel under cover sub-assembly.