Home › Vehicle Interior › SEAT BELT › REAR SEAT INNER BELT ASSEMBLY (for RH Side)

REAR SEAT INNER BELT ASSEMBLY (for RH Side) > INSTALLATION

for Preparation Click here



1. INSTALL REAR SEAT INNER BELT ASSEMBLY RH


    B221496E01
  1. Install the rear seat inner belt assembly RH with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

    Text in Illustration 
    *1
    Protruding Part

    NOTICE:
    Do not allow the anchor part of the rear seat inner belt assembly RH to overlap onto the protruding part of the floor panel.



2. INSTALL REAR SEAT INNER BELT ASSEMBLY RH (for Buckle with Switch)


    B226684E01
  1. Install the rear seat inner belt assembly RH with the bolt.
    Text in Illustration 
    *1
    Protruding Part

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

    NOTICE:
    Do not allow the anchor part of the rear sear inner belt assembly RH to overlap onto the protruding part of the floor panel.

  1. Engage the clamp to connect the connector.



3. INSTALL REAR SEATBACK ASSEMBLY RH (for Buckle with Switch)
  1. Place the rear seatback assembly RH in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.



    B230017
  1. Install the rear seatback assembly RH with the 2 bolts.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }



    B233147E01
  1. Engage the fastener.
    Text in Illustration 
    *1
    Fastener



4. CONNECT REAR CENTER SEAT BELT ASSEMBLY


    B221513E01
  1. Connect the anchor part of the rear seat inner belt assembly.
    Text in Illustration 
    *1
    Protruding Part

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

    NOTICE:
    Do not allow the anchor part of the rear center seat belt assembly to overlap the protruding part of the rear seat inner belt assembly RH.



5. INSTALL REAR SEAT HEADREST ASSEMBLY (for Buckle with Switch)


    B230013
  1. Install the rear seat headrest assembly RH as shown in the illustration.



6. INSTALL REAR SEAT CENTER HEADREST ASSEMBLY (for Buckle with Switch)


    B230016
  1. Install the rear seat center headrest assembly as shown in the illustration.



7. INSTALL REAR SEAT CUSHION ASSEMBLY


    B229993E01
  1. Engage the 2 guides of the seat cushion to the seatback.
    Text in Illustration 
    *1
    100 mm (3.94 in.) or less
    *2
    Guide
    *3
    Hook

  1. Engage the 2 front hooks of the seat cushion to the vehicle body.

    NOTICE:
    When installing the seat cushion, make sure that the seat belt buckle is not under the seat cushion.

    HINT:
    Confirm that the seat cushion is firmly installed.