Home › Vehicle Exterior › WIPER / WASHER › RELAY (w/ Headlight Cleaner System)

RELAY (w/ Headlight Cleaner System) > REMOVAL

for Preparation Click here



1. REMOVE RADIATOR SUPPORT OPENING COVER


    B228429
  1. Remove the 3 clips.

  1. Disengage the 2 claws and remove the radiator support opening cover.



2. REMOVE FRONT BUMPER ASSEMBLY


    B228430E01
  1. Put protective tape around the front bumper assembly.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    Use the same procedure for the RH side and LH side.



    B228431
  1. Using a screwdriver, turn the pins 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.



    B228433
  1. Remove the screw.

    HINT:
    Use the same procedure for the RH side and LH side.



    B228434
  1. Remove the 2 bolts and 4 screws.

  1. Using a clip remover, remove the 7 clips.



    B228436
  1. Using a clip remover, remove the 2 clips. (w/ Front Spoiler)

  1. Remove the 2 screws. (w/ Front Spoiler)

  1. Disengage the 2 guides and remove the front spoiler cover. (w/ Front Spoiler)



    B228439
  1. Disengage the 3 claws and remove the front bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Disconnect each connector.

  1. Disconnect the headlight cleaner hose and drain the washer fluid. (w/ Headlight Cleaner System)

    HINT:
    Use a container to collect the washer fluid.



    B228441
  1. Remove the front bumper assembly as shown in the illustration.



3. REMOVE INLET AIR CLEANER ASSEMBLY


    A212313
  1. Separate the water by-pass hose from the inlet air cleaner assembly.

  1. Separate the wire harness clamp from the inlet air cleaner assembly.

  1. Remove the 3 bolts and inlet air cleaner assembly.



4. REMOVE HEADLIGHT CLEANER CONTROL RELAY


    E190955
  1. Disengage the clip and separate the washer jar cap of the washer jar assembly.



    E190061
  1. Disconnect the 2 connectors.

  1. Disengage the clamp.

  1. Remove the 2 bolts.



    E190130
  1. Disengage the hose clamp.

  1. Disconnect the 2 washer hoses, and drain the washer fluid.

    HINT:
    Use a container to collect the washer fluid.



    E190131
  1. Disconnect the 2 connectors.

  1. Disengage the clamp.

  1. Remove the bolt and the washer jar assembly.



    E189278
  1. Disengage the claw and remove the headlight cleaner control relay as shown in the illustration.