Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG CUT-OFF SWITCH

AIRBAG CUT-OFF SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL AIRBAG CUT-OFF SWITCH CYLINDER SUB-ASSEMBLY


    B229740
  1. Engage the 2 claws to install the airbag cut-off switch cylinder sub-assembly.



2. INSTALL INSTRUMENT PANEL FINISH PANEL END RH


    B223491
  1. Engage the guide as shown in the illustration.



    B223489
  1. Engage the guide as shown in the illustration.



    B223488
  1. Engage the 4 claws to install the instrument panel finish panel end RH.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



4. INSTALL REAR NO. 3 FLOOR BOARD


    B227791
  1. Engage the 2 guides to install the rear No. 3 floor board.



5. INSTALL REAR DECK FLOOR BOX
  1. Install the rear deck floor box.



6. INSTALL REAR NO. 2 FLOOR BOARD


    B227788E01
  1. Engage the 3 guides <A>.

  1. Engage the 2 guides <B> and install the rear No. 2 floor board as shown in the illustration.



7. PERFORM DIAGNOSTIC SYSTEM CHECK
  1. Perform a diagnostic system check (Click here).



8. INSPECT SRS WARNING LIGHT
  1. Inspect the SRS warning light (Click here).