Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › INTELLIGENT PARKING ASSIST SYSTEM

INTELLIGENT PARKING ASSIST SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

HINT:
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the intelligent tester on.

  4. Enter the following menus: Chassis / Intelligent Parking Assist / Data List.

  5. According to the display on the intelligent tester, read the Data List.

    Intelligent Parking Assist 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    AVC-LAN Master Connect Status
    AVC-LAN communication condition/OK or NG
    OK: AVC-LAN communication condition normal
    NG: AVC-LAN communication condition abnormal
    -
    AVC-LAN Master Reset Status
    AVC-LAN communication condition/OK or NG
    OK: AVC-LAN communication condition normal
    NG: AVC-LAN communication condition abnormal
    -
    AVC-LAN Connect Status
    AVC-LAN communication condition/OK or NG
    OK: AVC-LAN communication condition normal
    NG: AVC-LAN communication condition abnormal
    -
    AVC-LAN Sending Status
    AVC-LAN communication condition/OK or NG
    OK: AVC-LAN communication condition normal
    NG: AVC-LAN communication condition abnormal
    -
    AVC-LAN Regist Complete Status
    AVC-LAN communication condition/OK or NG
    OK: AVC-LAN communication condition normal
    NG: AVC-LAN communication condition abnormal
    -
    AVC-LAN Regist Request Status
    AVC-LAN communication condition/OK or NG
    OK: AVC-LAN communication condition normal
    NG: AVC-LAN communication condition abnormal
    -
    RHD/LHD Signal Check
    RHD/LHD signal information/OK or NG
    OK: Communication condition available
    NG: Communication condition not available
    OK: Value stored in parking assist ECU matches vehicle information
    NG: Value stored in parking assist ECU does not match vehicle information
    Destination Data Check
    Destination data information/OK or NG
    OK: Communication condition available
    NG: Communication condition not available
    OK: Value stored in parking assist ECU matches vehicle information
    NG: Value stored in parking assist ECU does not match vehicle information
    ROM/SUM Check
    Parking assist ECU information/OK or NG
    OK: Parking assist ECU normal
    NG: Parking assist ECU abnormal
    -
    Mirror Check
    Parking assist ECU information/OK or NG
    OK: Parking assist ECU normal
    NG: Parking assist ECU abnormal
    -
    High-Speed RAM Check
    Parking assist ECU information/OK or NG
    OK: Parking assist ECU normal
    NG: Parking assist ECU abnormal
    -
    EEPROM Status (Initial read)
    Parking assist ECU information/OK or NG
    OK: Parking assist ECU normal
    NG: Parking assist ECU abnormal
    -
    RAM Check
    Parking assist ECU information/OK or NG
    OK: Parking assist ECU normal
    NG: Parking assist ECU abnormal
    -
    IG Voltage Low Status
    IG voltage input to parking assist ECU/OK or NG
    OK: IG voltage normal
    NG: IG voltage abnormal (too low)
    -
    IG Voltage High Status
    IG voltage input to parking assist ECU/OK or NG
    OK: IG voltage normal
    NG: IG voltage abnormal (too high)
    -
    ACC Voltage Low Status
    ACC voltage input to parking assist ECU/OK or NG
    OK: ACC voltage normal
    NG: ACC voltage abnormal (too low)
    -
    ACC Voltage High Status
    ACC voltage input to parking assist ECU/OK or NG
    OK: ACC voltage normal
    NG: ACC voltage abnormal (too high)
    -
    CPU Busy Status
    Parking assist ECU information/OK or NG
    OK: Parking assist ECU normal
    NG: Parking assist ECU abnormal
    -
    CPU Communication Status
    Parking assist ECU information/OK or NG
    OK: Parking assist ECU normal
    NG: Parking assist ECU abnormal
    -
    Integer Arithmetic Status
    Parking assist ECU information/OK or NG
    OK: Parking assist ECU normal
    NG: Parking assist ECU abnormal
    -
    FPU Calculation Status
    Parking assist ECU information/OK or NG
    OK: Parking assist ECU normal
    NG: Parking assist ECU abnormal
    -
    ASIC Output Status
    Output condition of camera display signal/OK or NG
    OK: Output condition of camera display signal normal
    NG: Output condition of camera display signal abnormal
    -
    EPS Status
    EPS (Power Steering System) status/OK or NG
    OK: EPS available
    NG: EPS not available
    -
    Wheel Speed Sensor (4wheel)
    Vehicle speed signal from speed sensor/OK or NG
    OK: Speed signal normal
    NG: Speed signal abnormal
    -
    Height Sensor Volt Status (L)
    Power supply for rear height control sensor sub-assembly RH (Low)/OK or NG
    OK: Power supply for rear height control sensor sub-assembly RH normal
    NG: Power supply for rear height control sensor sub-assembly RH abnormal
    -
    Height Sensor Volt Status (H)
    Power supply for rear height control sensor sub-assembly RH (High)/OK or NG
    OK: Power supply for rear height control sensor sub-assembly RH normal
    NG: Power supply for rear height control sensor sub-assembly RH abnormal
    -
    Height Sensor Status
    Vehicle height signal from rear height control sensor sub-assembly RH/OK or NG
    OK: Signal from rear height control sensor sub-assembly RH normal
    NG: Signal from rear height control sensor sub-assembly RH abnormal
    -
    Height Sensor Status (Fixing)
    Vehicle height signal from rear height control sensor sub-assembly RH (Fixed)/OK or NG
    OK: Rear height control sensor sub-assembly RH normal
    NG: Rear height control sensor sub-assembly RH fixed
    -
    FLS Sensor Status (Left)
    No. 1 ultrasonic sensor (for LH side) condition/OK or NG
    OK: No. 1 ultrasonic sensor (for LH side) normal
    NG: No. 1 ultrasonic sensor (for LH side) abnormal
    -
    FLS Sensor Status (Right)
    No. 1 ultrasonic sensor (for RH side) condition/OK or NG
    OK: No. 1 ultrasonic sensor (for RH side) normal
    NG: No. 1 ultrasonic sensor (for RH side) abnormal
    -
    Temp Sensor Activate Status
    Ambient temperature sensor status/valid or invalid
    OK: Ambient temperature sensor available
    NG: Ambient temperature sensor not available
    -
    Temp Sensor Status
    Ambient temperature sensor status/OK or NG
    OK: Ambient temperature sensor available
    NG: Ambient temperature sensor not available
    -
    A/C Communication Status
    Communication condition to air conditioning amplifier assembly/OK or NG
    OK: Communication condition available
    NG: Communication condition not available
    -
    AVC-LAN Output On Resp
    AVC-LAN communication condition/OK or Timeout
    OK: AVC-LAN communication condition normal
    Timeout: AVC-LAN communication condition abnormal
    -
    AVC-LAN Output Off Resp
    AVC-LAN communication condition/OK or Timeout
    OK: AVC-LAN communication condition normal
    Timeout: AVC-LAN communication condition abnormal
    -
    AVC-LAN Start Sound Resp
    AVC-LAN communication condition/OK or Timeout
    OK: AVC-LAN communication condition normal
    Timeout: AVC-LAN communication condition abnormal
    -
    AVC-LAN Finish Sound Resp
    AVC-LAN communication condition/OK or Timeout
    OK: AVC-LAN communication condition normal
    Timeout: AVC-LAN communication condition abnormal
    -
    Continuous Bus Off
    Continuous bus off/Not detected or detected
    Not detected: Communication condition available
    Detected: Communication condition not available
    -
    Sending CAN Message
    Communication condition from parking assist ECU/OK or NG
    OK: Communication condition available
    NG: Communication condition not available
    -
    ACC Terminal
    ACC power supply voltage value/0 to 5 V
    Power switch on (ACC)
    Approx. 5 V
    -
    IG Terminal
    IG power supply voltage value/0 to 5 V
    Power switch on (IG)
    Approx. 5 V
    -
    Camera Select SW Terminal
    Camera Select SW power supply voltage value/0 to 5 V
    Approx. 5 V
    Not Supported
    Rev Terminal
    Reverse signal power supply voltage value/0 to 5 V
    Approx. 0 V
    Not Supported
    IPA Select SW terminal
    Parking assist pre support switch assembly signal value/0 to 5V
    Parking assist pre support switch on: Below 1 V
    Parking assist pre support switch off: Approx. 5 V
    -
    CS Main SW Terminal
    Clearance sonar switch assembly signal value/0 to 5V
    Clearance sonar switch assembly signal on: Approx. 5 V
    Clearance sonar switch assembly signal off: Below 1 V
    Not Supported
    H Sens Signal Output Terminal
    Rear height control sensor signal value/0 to 5 V
    Approx. 2.5 V (When vehicle is level)
    Value changes according to vehicle height
    H Sens PWR Terminal
    Height control sensor power supply value/0 to 5 V
    Approx. 5 V
    -
    H Sens Signal Input Terminal
    Rear height control sensor signal value/0 to 5 V
    Approx. 2.5 V (When vehicle is level)
    Value changes according to vehicle height
    Mirror Storage Signal
    Mirror switch signal/ON or OFF
    ON: Mirror switch pushed
    OFF: Mirror switch not pushed
    Not Supported
    Back Door Courtesy Signal
    Back door courtesy switch signal/ON or OFF
    ON: Back door open
    OFF: Back door closed
    Not Supported
    R Range Count
    R Range Count
    Min.: 0
    Max.: 65535 time
    R Range Count will be displayed
    -
    Shed/Parallel Parking Count
    Shed/Parallel Parking Count
    Min.: 0
    Max.: 65535 time
    Shed/Parallel Parking Count will be displayed
    -
    IPA Mode Count
    IPA Mode Count
    Min.: 0
    Max.: 65535 time
    IPA Mode Count will be displayed
    -
    Image ASIC Status
    ASIC inside status/OK or NG
    OK: Parking assist ECU normal
    NG: Parking assist ECU abnormal
    -
    Number of DTC
    Number of stored trouble codes/min.: 0, max.: 255
    Number of DTCs will be displayed
    -