FRONT PASSENGER SEAT BELT WARNING LIGHT > INSTALLATION |
| 1. INSTALL PASSENGER SEAT BELT WARNING LIGHT ASSEMBLY |
![]() |
Engage the 2 claws and install the passenger seat belt warning light assembly as shown in the illustration.
| 2. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH |
Connect the connector.
Engage the 7 claws.
Install the center instrument cluster finish panel garnish with the 2 screws <C>.

| 3. INSTALL GLOVE COMPARTMENT DOOR |
Open the glove compartment door assembly.
![]() |
Insert the glove compartment door as shown in the illustration.
Engage the 7 claws to install the glove compartment door.
| 4. INSTALL NO. 2 INSTRUMENT PANEL REGISTER |
![]() |
Engage the 3 claws and clip to install the No. 2 instrument panel register.
| 5. INSTALL NO. 1 SIDE DEFROSTER NOZZLE |
![]() |
Engage the 3 claws to install the No. 1 side defroster nozzle.
| 6. INSTALL NAVIGATION RECEIVER WITH BRACKET (w/ Navigation System) |
![]() |
Engage the 4 claws to temporarily install the navigation receiver assembly with bracket as shown in the illustration.
![]() |
Install the navigation receiver assembly with bracket with the 4 bolts.
| 7. INSTALL RADIO RECEIVER WITH BRACKET (w/o Navigation System) |
Connect each connector.
![]() |
Engage the 4 claws as shown in the illustration.
![]() |
Install the radio receiver with bracket with the 4 bolts.
| 8. INSTALL RADIO TUNER OPENING COVER WITH BRACKET (w/o Radio Receiver) |
![]() |
Install the radio tuner opening cover with bracket with the 4 bolts <B>.
| 9. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (w/o Radio Receiver) |
![]() |
Engage the 4 claws to install the center instrument cluster finish panel sub-assembly.
| 10. INSTALL UPPER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY |
![]() |
Connect the connector.
Engage the 3 claws to install the upper instrument panel finish panel sub-assembly.
| 11. INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH |
Connect the connector.
Engage the 14 claws to install the instrument cluster finish panel garnish.

| 12. INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY |
![]() |
Engage the 7 claws and 2 clips to install the lower center instrument cluster finish panel sub-assembly.
| 13. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY |
![]() |
Connect each connector.
Engage the 6 claws to install the integration control and panel assembly.
| 14. CONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 15. INSTALL REAR NO. 3 FLOOR BOARD |
![]() |
Engage the 2 guides to install the rear No. 3 floor board.
| 16. INSTALL REAR DECK FLOOR BOX |
Install the rear deck floor box.
| 17. INSTALL REAR NO. 2 FLOOR BOARD |
![]() |
Engage the 3 guides <A>.
Engage the 2 guides <B> and install the rear No. 2 floor board as shown in the illustration.
| 18. INSPECT SRS WARNING LIGHT |
Inspect the SRS warning light (Click here).