NOISE FILTER > INSTALLATION |
| 1. INSTALL NOISE FILTER |
![]() |
Engage the claw to install a new terminal cover to the wire harness.
![]() |
Engage the 3 claws to install the new terminal cover with the wire harness to a new condenser.
![]() |
Engage the clamp to temporarily install a new noise filter with the wire harness to the back door.
Install the new noise filter with the bolt.
| 2. INSTALL BACK DOOR TRIM BOARD ASSEMBLY |
![]() |
Engage the 11 clips and 2 claws to install the back door panel trim assembly.