NOISE FILTER > INSTALLATION |
| 1. INSTALL RADIO SETTING CONDENSER |
![]() |
Engage the claw to install a new terminal cover to the wire harness.
![]() |
Engage the 3 claws to install the new terminal cover with the wire harness to a new condenser.
Engage the clamp to temporarily install a new radio setting condenser with the wire harness.
Install the new radio setting condenser with the nut.
| 2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH |
Connect the connector.
Engage the 7 claws and 2 clips.
Install the deck trim side panel assembly LH with the screw.

| 3. INSTALL TONNEAU COVER HOLDER CAP |
![]() |
Engage the claw to install the tonneau cover holder cap.
| 4. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY |
![]() |
Engage the 2 guides.
Install the 2 luggage hold belt striker assemblies with the 2 bolts.
| 5. INSTALL REAR SIDE SEATBACK ASSEMBLY LH |
![]() |
Engage the 2 guides as shown in the illustration.
![]() |
Install the rear side seatback assembly LH with the bolt.
| 6. INSTALL REAR SEAT CUSHION ASSEMBLY |
![]() |
Engage the 2 guides of the seat cushion to the seatback.
| *1 | 100 mm (3.94 in.) or less |
| *2 | Guide |
| *3 | Hook |
Engage the 2 front hooks of the seat cushion to the vehicle body.
| 7. INSTALL REAR DECK TRIM COVER |
![]() |
Engage the 4 claws and 4 guides to install the rear deck trim cover.
| 8. INSTALL DECK TRIM SERVICE HOLE COVER |
![]() |
Engage the 3 guides.
Engage the 2 claws to install the deck trim service hole cover.
| 9. INSTALL REAR NO. 1 FLOOR BOARD |
![]() |
Engage the 2 claws and 2 clips.
Install the rear No. 1 floor board with the bolt.
| 10. INSTALL REAR NO. 2 FLOOR BOARD SUB-ASSEMBLY |
![]() |
Engage the claw and 2 clips to install the rear No. 2 floor board sub-assembly.
| 11. INSTALL REAR NO. 1 FLOOR BOARD SUB-ASSEMBLY |
![]() |
Engage the 2 claws and 2 clips to install the rear No. 1 floor board sub-assembly.
| 12. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) |
Install the tonneau cover assembly.
| 13. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH |
![]() |
Align the alignment mark (Red) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the rear door opening trim weatherstrip LH.
| *1 | Alignment Mark (Red) |
| 14. INSTALL REAR DOOR SCUFF PLATE LH |
![]() |
Engage the 7 claws to install the rear door scuff plate LH.
| 15. INSTALL DECK FLOOR BOX LH |
![]() |
Engage the 2 guides.
Install the deck floor box LH with the clip.
| 16. INSTALL REAR NO. 4 FLOOR BOARD |
![]() |
Engage the guide to install the rear No. 4 floor board.
| 17. INSTALL REAR DECK FLOOR BOX |
Install the rear deck floor box.
| 18. INSTALL REAR NO. 2 FLOOR BOARD |
![]() |
Engage the 3 guides <A>.
Engage the 2 guides <B> and install the rear No. 2 floor board as shown in the illustration.