Home › Vehicle Interior › SEAT BELT › OCCUPANT DETECTION SENSOR

OCCUPANT DETECTION SENSOR > REMOVAL

for Preparation Click here



1. PRECAUTION (w/ Navigation System for HDD)

NOTICE:
After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE REAR NO. 2 FLOOR BOARD


    B227787E01
  1. Disengage the 2 guides <A> as shown in the illustration.

  1. Disengage the 3 guides <B> and remove the rear No. 2 floor board.



3. REMOVE REAR DECK FLOOR BOX
  1. Remove the rear deck floor box.



4. REMOVE REAR NO. 3 FLOOR BOARD


    B227791
  1. Disengage the 2 guides and remove the rear No. 3 floor board.



5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



6. REMOVE FRONT SEAT HEADREST ASSEMBLY

HINT:
Use the same procedure described for the LH side .



7. REMOVE OUTER SEAT TRACK COVER

HINT:
Use the same procedure described for the LH side .



8. REMOVE INNER SEAT TRACK COVER

HINT:
Use the same procedure described for the LH side .



9. REMOVE FRONT SEAT ASSEMBLY

HINT:
Use the same procedure described for the LH side .



10. REMOVE RECLINING ADJUSTER RELEASE HANDLE

HINT:
Use the same procedure described for the LH side .



11. REMOVE VERTICAL ADJUSTING HANDLE (w/ Vertical Adjuster)

HINT:
Use the same procedure described for the LH side .



12. REMOVE FRONT SEAT CUSHION SHIELD ASSEMBLY

HINT:
Use the same procedure described for the LH side .



13. REMOVE FRONT SEAT INNER BELT ASSEMBLY

HINT:
Use the same procedure described for the LH side .



14. REMOVE FRONT SEAT CUSHION INNER SHIELD

HINT:
Use the same procedure described for the LH side .



15. REMOVE FRONT SEAT CUSHION COVER WITH PAD

HINT:
Use the same procedure described for the LH side .



16. REMOVE OCCUPANT DETECTION SENSOR


    B232849
  1. Remove the 2 hog rings.



    B229846
  1. Remove the 11 hog rings and separate type front seat cushion cover.