Home › Vehicle Interior › HEATING / AIR CONDITIONING › SOLAR VENTILATION SYSTEM

SOLAR VENTILATION SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / Air Conditioner / Data List.

  5. Check the value(s) by referring to the table below.

    Air Conditioner 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Solar Ventilation Switch
    Solar ventilation switch (Switch recognition value at A/C amplifier side) /
    OFF or ON
    OFF: Solar ventilation switch off
    ON: Solar ventilation switch on
    -
    Solar Voltage
    Solar panel voltage /
    10V les, 10V-11V, 11V-12V, 12V-13V, 13V-14V, 14V-15V, 15V-16V, 16V-17V, 17V-18V, 18V-19V, 19V-20V, 20V-21V, 21V-22V, 22V-23V or 23V ovr
    Actual generated voltage displayed
    System operation requirements are met (Click here).
    Solar Ventilation Switch Status
    Solar ventilation switch (Switch recognition value at solar ventilation ECU side) /
    OFF or ON
    OFF: Solar ventilation switch off
    ON: Solar ventilation switch on
    -
    Solar IG Status
    Solar ventilation ECU IG status /
    OFF or ON
    OFF: Power switch off
    ON: Power switch on (IG)
    When OFF is displayed, a malfunction in the solar ventilation ECU is suspected.
    Solar Ventilation Test Mode Status
    Solar ventilation ECU test mode status /
    OFF or ON
    OFF: Test mode off
    ON: Test mode on
    -

    HINT:
    If the Data List items related to the solar ventilation system are not displayed, the following conditions are suspected:
    1. The voltage generated by the moon roof glass assembly (solar panel) is less than 7 V (Click here).
    2. There is a communication error between the solar ventilation ECU and A/C amplifier (Click here).


ACTIVE TEST
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
  1. Connect the intelligent tester to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / Air Conditioner / Active Test.

  5. Check the operation by referring to the table below.

    Air Conditioner 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Blower Motor
    Blower motor
    Min.: 0, Max.: 31
    -