Home › Vehicle Interior › INTERIOR PANELS / TRIM › ROOF HEADLINING

ROOF HEADLINING > DISASSEMBLY

for Preparation Click here



1. REMOVE VANITY LIGHT ASSEMBLY
  1. Remove the vanity light assembly .

    HINT:
    Use the same procedure for the other vanity light.



2. REMOVE NO. 2 ROOF SILENCER PAD (w/o Sliding Roof)


  1. Remove the No. 2 roof silencer pad from the roof headlining assembly.


    B228248



3. REMOVE NO. 3 ROOF SILENCER PAD (w/o Sliding Roof)


  1. Remove the No. 3 roof silencer pad from the roof headlining assembly.


    B228252



4. REMOVE NO. 4 ANTENNA CORD SUB-ASSEMBLY


  1. Peel the strips of the tape used to secure the antenna cord only to the extent that allows removal of the antenna cord.


    E191249E03


    Text in Illustration 
    *A
    w/o Sliding Roof
    *B
    w/ Sliding Roof
    *1
    Tape
    -
    -
    *a
    Front
    -
    -

  1. Remove the No. 4 antenna cord sub-assembly.



5. REMOVE NO. 1 ROOF WIRE


  1. Remove the adhesive tape from the roof headlining assembly.


    B228255E01


    Text in Illustration 
    *1
    Adhesive Tape
    -
    -

  1. Turn the visor connectors counterclockwise approximately 45° and separate the connectors and each clamp from the roof headlining assembly.



  1. Remove the No. 1 roof wire from the roof headlining assembly.


    B228263E01


    Text in Illustration 
    *1
    w/ EC Mirror
    *2
    w/ Rain Sensor