Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › FRONT SPEED SENSOR

FRONT SPEED SENSOR > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the LH side and RH side.
  2. The following procedure is for the LH side.
  3. If the sensor rotor needs to be replaced, replace it together with the front axle hub and bearing assembly.



1. INSTALL FRONT SPEED SENSOR


    C208049
  1. Install the front speed sensor with the bolt.

    Torque:
    8.5 N*m{ 87 kgf*cm , 76 in.*lbf }

    NOTICE:
    1. Prevent foreign matter from attaching to the front speed sensor tip.
    2. Firmly insert the front speed sensor body into the knuckle before tightening the bolt.
    3. After installing the front speed sensor to the knuckle, make sure that there is no clearance between the front speed sensor stay and knuckle. Also make sure that no foreign matter is stuck between the parts.
    4. Before installing the clamp, firmly insert the points of the clamp into the installation holes.



  1. Temporarily install the front brake flexible hose.


    C208044E01


    Text in Illustration 
    *1
    Front Brake Flexible Hose
    *2
    No. 1 Sensor Clamp

  1. Install the front brake flexible hose and No. 1 sensor clamp together to the shock absorber with the bolt.

    Torque:
    19 N*m{ 192 kgf*cm , 14 ft.*lbf }

    NOTICE:
    1. Do not twist the wire harness for the front speed sensor when installing the speed sensor.
    2. Bolt tightens the brake flexible hose and front speed sensor together. Make sure that the front speed sensor is positioned over the front brake flexible hose.



    C208045
  1. Install the clamp to the shock absorber assembly.



    C208048E01
  1. Install the No. 2 sensor clamp to the body with the bolt.

    Torque:
    8.5 N*m{ 87 kgf*cm , 76 in.*lbf }

    Text in Illustration 
    *1
    No. 2 Sensor Clamp



    C208046
  1. Connect the speed sensor connector.

  1. Connect the 2 speed sensor wire harness clamps to the body.



2. INSTALL FRONT FENDER LINER


    C208383
  1. Install the front fender liner with the 12 clips, 3 grommets and 4 screws.



3. INSTALL FRONT WHEEL

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



5. INSTALL REAR NO. 3 FLOOR BOARD


    B227791
  1. Engage the 2 guides to install the rear No. 3 floor board.



6. INSTALL REAR DECK FLOOR BOX
  1. Install the rear deck floor box.



7. INSTALL REAR NO. 2 FLOOR BOARD


    B227788E01
  1. Engage the 3 guides <A>.

  1. Engage the 2 guides <B> and install the rear No. 2 floor board as shown in the illustration.



8. CHECK FOR SPEED SENSOR SIGNAL
(Click here)