FRONT SPEED SENSOR > INSTALLATION |
| 1. INSTALL FRONT SPEED SENSOR |
![]() |
Install the front speed sensor with the bolt.
Temporarily install the front brake flexible hose.

| *1 | Front Brake Flexible Hose | *2 | No. 1 Sensor Clamp |
Install the front brake flexible hose and No. 1 sensor clamp together to the shock absorber with the bolt.
![]() |
Install the clamp to the shock absorber assembly.
![]() |
Install the No. 2 sensor clamp to the body with the bolt.
| *1 | No. 2 Sensor Clamp |
![]() |
Connect the speed sensor connector.
Connect the 2 speed sensor wire harness clamps to the body.
| 2. INSTALL FRONT FENDER LINER |
![]() |
Install the front fender liner with the 12 clips, 3 grommets and 4 screws.
| 3. INSTALL FRONT WHEEL |
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 5. INSTALL REAR NO. 3 FLOOR BOARD |
![]() |
Engage the 2 guides to install the rear No. 3 floor board.
| 6. INSTALL REAR DECK FLOOR BOX |
Install the rear deck floor box.
| 7. INSTALL REAR NO. 2 FLOOR BOARD |
![]() |
Engage the 3 guides <A>.
Engage the 2 guides <B> and install the rear No. 2 floor board as shown in the illustration.
| 8. CHECK FOR SPEED SENSOR SIGNAL |