Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › SKID CONTROL BUZZER (for LHD)

SKID CONTROL BUZZER (for LHD) > REMOVAL

for Preparation Click here


NOTICE:
While the battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the battery is connected.



1. REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY
(Click here)


2. REMOVE SKID CONTROL BUZZER ASSEMBLY


    C208057E01
  1. Remove the skid control buzzer assembly.

  1. Disconnect the skid control buzzer connector.