SKID CONTROL BUZZER (for RHD) > REMOVAL |
| 1. PRECAUTION |
| 2. REMOVE REAR NO. 2 FLOOR BOARD |
![]() |
Disengage the 2 guides <A> as shown in the illustration.
Disengage the 3 guides <B> and remove the rear No. 2 floor board.
| 3. REMOVE REAR DECK FLOOR BOX |
Remove the rear deck floor box.
| 4. REMOVE REAR NO. 3 FLOOR BOARD |
![]() |
Disengage the 2 guides and remove the rear No. 3 floor board.
| 5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 6. REMOVE FRONT DOOR SCUFF PLATE RH |
| 7. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH |
| 8. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL |
| 9. REMOVE ECU INTEGRATION BOX RH |
Disconnect the connectors.
![]() |
Remove the nut, bolt and ECU integration box RH.
| 10. REMOVE SKID CONTROL BUZZER ASSEMBLY |
![]() |
Remove the skid control buzzer assembly.
Disconnect the skid control buzzer connector.