FRONT CONSOLE BOX > DISASSEMBLY |
| 1. REMOVE CONSOLE BOX POCKET |
![]() |
Disengage the 2 claws and remove the console box pocket as shown in the illustration.
| 2. REMOVE CONSOLE REAR END PANEL |
![]() |
Disengage the 10 claws to remove the console rear end panel.
| 3. REMOVE CONSOLE COMPARTMENT DOOR SUB-ASSEMBLY |
![]() |
Using a screwdriver, pull out the box door hinge shafts.
Remove the console compartment door sub-assembly.
| 4. REMOVE REAR CONSOLE COMPARTMENT DOOR BOX COVER |
![]() |
Remove the 4 screws.
![]() |
Remove the 4 screws and the outer console compartment door.
![]() |
Pull the rear console compartment door box cover in the direction indicated by the arrow to disengage the 2 claws and 5 guides, and remove the rear console compartment door box cover.
| 5. REMOVE NO. 2 CONSOLE COMPARTMENT DOOR INSERT |
![]() |
Pull the No. 2 console compartment door insert in the direction indicated by the arrow to disengage the 3 claws and 7 guides, and remove the No. 2 console compartment door insert.
| 6. REMOVE NO. 1 CONSOLE COMPARTMENT DOOR INSERT |
| 7. REMOVE CONSOLE COMPARTMENT DOOR CUSHION |
![]() |
Disengage the 4 claws and remove the inner console compartment door.
![]() |
Remove the console compartment door cushion.
| 8. REMOVE NO. 2 BOX SIDE PANEL |
![]() |
Remove the 2 screws.
![]() |
Pull the No. 2 box side panel in the direction indicated by the arrow to disengage the 9 claws and guide, and remove the No. 2 box side panel.
| 9. REMOVE NO. 1 BOX SIDE PANEL |
| 10. REMOVE CONSOLE COMPARTMENT DOOR CUSHION |
Remove the 2 console compartment door cushions.
| 11. REMOVE CIGARETTE LIGHTER WIRE ASSEMBLY |
![]() |
Disconnect the 2 connectors.
Disengage the clamp and remove the cigarette lighter wire assembly.
| 12. REMOVE STEREO JACK ADAPTER ASSEMBLY |
![]() |
Disconnect the connector.
Disengage the 2 claws and remove the stereo jack adapter assembly.
| 13. REMOVE CENTER POWER OUTLET SOCKET ASSEMBLY |
Disconnect the connector.
![]() |
Using a screwdriver, disengage the claw and remove the center power outlet socket assembly.
| *1 | Protective Tape |
| 14. REMOVE CENTER POWER OUTLET SOCKET COVER |
![]() |
Disengage the 2 claws and remove the center power outlet socket cover.