FRONT CONSOLE BOX > REASSEMBLY |
| 1. INSTALL CENTER POWER OUTLET SOCKET COVER |
![]() |
Engage the 2 claws and install the center power outlet socket cover.
| 2. INSTALL CENTER POWER OUTLET SOCKET ASSEMBLY |
![]() |
Engage the claw and install the center power outlet socket assembly.
Connect the connector.
| 3. INSTALL STEREO JACK ADAPTER ASSEMBLY |
![]() |
Engage the 2 claws to install the stereo jack adapter assembly.
Connect the connector.
| 4. INSTALL CIGARETTE LIGHTER WIRE ASSEMBLY |
![]() |
Engage the clamp.
Connect the 2 connectors to install the cigarette lighter wire assembly.
| 5. INSTALL CONSOLE COMPARTMENT DOOR CUSHION |
Install the 2 console compartment door cushions.
| 6. INSTALL NO. 2 BOX SIDE PANEL |
![]() |
Engage the 9 claws and guide as shown in the illustration.
![]() |
Install the No. 2 box side panel with the 2 screws.
| 7. INSTALL NO. 1 BOX SIDE PANEL |
| 8. INSTALL CONSOLE COMPARTMENT DOOR CUSHION |
![]() |
Install a new console compartment door cushion.
![]() |
Engage the 4 claws to install the inner console compartment door.
| 9. INSTALL NO. 2 CONSOLE COMPARTMENT DOOR INSERT |
![]() |
Engage the 3 claws and 7 guides to install the No. 2 console compartment door insert as shown in the illustration.
| 10. INSTALL NO. 1 CONSOLE COMPARTMENT DOOR INSERT |
| 11. INSTALL REAR CONSOLE COMPARTMENT DOOR BOX COVER |
![]() |
Engage the 2 claws and 5 guides to install the rear console compartment door box cover as shown in the illustration.
![]() |
Temporarily install the outer console compartment door with the 4 screws.
![]() |
Install the outer console compartment door with the 4 screws.
| 12. INSTALL CONSOLE COMPARTMENT DOOR SUB-ASSEMBLY |
Temporarily install the console compartment door sub-assembly.
![]() |
Push in the box door hinge shafts by hand as far as possible.
![]() |
Using pliers, push in the box door hinge shafts completely and install the console compartment door sub-assembly.
| 13. INSTALL CONSOLE REAR END PANEL |
![]() |
Engage the 10 claws to install the console rear end panel.
| 14. INSTALL CONSOLE BOX POCKET |
![]() |
Engage the 2 claws and install the console box pocket as shown in the illustration.