DTC C2309 Open in B+ Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| C2309 | With the power switch on (IG), voltage of transmission control ECU terminal +B is 3 V or less for 1 second or more. |
|

| 1.READ VALUE USING INTELLIGENT TESTER (IG(+B) VOLTAGE VALUE) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Chassis / Transmission Control / Data List / IG(+B) Voltage Value.
Read the Data List displayed on the intelligent tester.
| Result | Proceed to |
| 3 V or less | A |
| Other than above | B |
Turn the power switch off.
|
| ||||
| A | |
| 2.READ VALUE USING INTELLIGENT TESTER (BATTERY VOLTAGE VALUE) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Chassis / Transmission Control / Data List / Battery Voltage Value.
Read the Data List displayed on the intelligent tester.
| Result | Proceed to |
| 9 V or more | A |
| Other than above | B |
Turn the power switch off.
|
| ||||
| A | |
| 3.CHECK HARNESS AND CONNECTOR (TRANSMISSION CONTROL ECU ASSEMBLY - IGCT NO. 2 FUSE) |
Disconnect the A23 transmission control ECU assembly connector.
Remove the IGCT No. 2 fuse from the engine room junction block assembly.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A23-16 (+B) - 2 (IGCT No. 2 fuse) | Power switch off | Below 1 Ω |
| Tester Connection | Switch Condition | Specified Condition |
| A23-16 (+B) - Body ground and other terminals | Power switch off | 10 kΩ or higher |
| *1 | Front view of wire harness connector (to Transmission Control ECU Assembly) |
| *2 | Engine Room Junction Block Assembly |
| *3 | IGCT No. 2 fuse |
Install the IGCT No. 2 fuse.
Connect the transmission control ECU assembly connector.
|
| ||||
| OK | ||
| ||