Home › Vehicle Interior › SEAT › LUMBAR SWITCH (for Manual Seat)

LUMBAR SWITCH (for Manual Seat) > INSPECTION

for Preparation Click here



1. INSPECT LUMBAR SWITCH (for LHD)


    B165793E15
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Hold
    Below 1 Ω
    1 - 2
    Off
    Below 1 Ω
    1 - 2
    Release
    10 kΩ or higher
    3 - 4
    Hold
    Below 1 Ω
    3 - 4
    Release
    10 kΩ or higher
    5 - 4
    Hold
    10 kΩ or higher
    5 - 4
    Off
    Below 1 Ω
    5 - 4
    Release
    Below 1 Ω
    1 - 3
    Hold
    10 kΩ or higher
    1 - 3
    Release
    Below 1 Ω

    Text in Illustration 
    *1
    Hold
    *2
    Release
    *3
    Component without harness connected
    (Lumbar Switch LH)
    If the result is not as specified, replace the lumbar switch.



2. INSPECT LUMBAR SWITCH (for RHD)


    B190725E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Hold
    Below 1 Ω
    1 - 2
    Off
    Below 1 Ω
    1 - 2
    Release
    10 kΩ or higher
    3 - 4
    Hold
    Below 1 Ω
    3 - 4
    Release
    10 kΩ or higher
    5 - 4
    Hold
    10 kΩ or higher
    5 - 4
    Off
    Below 1 Ω
    5 - 4
    Release
    Below 1 Ω
    1 - 3
    Hold
    10 kΩ or higher
    1 - 3
    Release
    Below 1 Ω

    Text in Illustration 
    *1
    Hold
    *2
    Release
    *3
    Component without harness connected
    (Lumbar Switch RH)
    If the result is not as specified, replace the lumbar switch.