Home › Vehicle Interior › HEATING / AIR CONDITIONING › SOLAR VENTILATION SWITCH

SOLAR VENTILATION SWITCH > INSPECTION

for Preparation Click here



1. INSPECT SOLAR VENTILATION SWITCH


    E191637E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    9 (SW+) - 6 (SW-)
    Solar ventilation switch: off
    10 kΩ or higher
    9 (SW+) - 6 (SW-)
    Solar ventilation switch: on
    Below 1 Ω

    Text in Illustration 
    *1
    Component without harness connected
    (Solar Ventilation Switch)
    If the resistance is not as specified, replace the solar ventilation switch.