SEAT BELT CONTROL ECU > INSTALLATION |
| 1. INSTALL SEAT BELT CONTROL ECU (for LHD) |
![]() |
Engage the 2 claws to install the seat belt control ECU.
| 2. INSTALL SEAT BELT CONTROL ECU (for RHD) |
![]() |
Engage the 2 claws to install the seat belt control ECU.
| 3. INSTALL ECU INTEGRATION BOX RH (for LHD) |
Connect each connector.
![]() |
Install the ECU integration box RH with the bolt and 2 nuts.
| 4. INSTALL ECU INTEGRATION BOX LH (for RHD) |
Connect each connector.
![]() |
Install the ECU integration box LH with the bolt and nut.
| 5. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY |
![]() |
With the glove compartment door assembly opened approximately 55° from its closed position, engage the 2 hinges horizontally.
| *a | Opened Approximately 55° |
| *b | Closed |
![]() |
Slightly bend the stoppers (A) and (B) in the directions indicated by the arrows in the illustration and engage the stoppers to install the glove compartment door assembly.
| *1 | Glove Compartment Door Stopper Sub-assembly |
| *2 | Stopper |
Engage the claw and connect the glove compartment door stopper sub-assembly.
| 6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 7. INSTALL REAR NO. 3 FLOOR BOARD |
![]() |
Engage the 2 guides to install the rear No. 3 floor board.
| 8. INSTALL REAR DECK FLOOR BOX |
Install the rear deck floor box.
| 9. INSTALL REAR NO. 2 FLOOR BOARD |
![]() |
Engage the 3 guides <A>.
Engage the 2 guides <B> and install the rear No. 2 floor board as shown in the illustration.