COMBINATION METER > DISASSEMBLY |
| 1. REMOVE INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY |
![]() |
Remove the 6 screws and instrument panel finish panel sub-assembly.
| 2. REMOVE NO. 3 COMBINATION METER COVER |
![]() |
Remove the 3 screws.
![]() |
Disengage the 7 claws and 2 guides to remove the No. 3 combination meter cover.
| 3. REMOVE METER CIRCUIT PLATE |
![]() |
Disconnect the connector as shown in the illustration.
![]() |
Disengage the 2 guides to remove the meter circuit plate.
| 4. REMOVE NO. 2 COMBINATION METER COVER |
![]() |
Disengage the 2 guides to remove the No. 2 combination meter cover.
| 5. REMOVE NO. 1 COMBINATION METER COVER |
![]() |
Disengage the 2 guides to remove the No. 1 combination meter cover.
| 6. REMOVE NO. 4 COMBINATION METER COVER |
![]() |
Remove the 7 screws.
![]() |
Disengage the 6 claws to remove the No. 4 combination meter cover.
| 7. REMOVE NO. 2 METER CIRCUIT PLATE |
![]() |
Disconnect the connector as shown in the illustration.
![]() |
Disengage the 2 guides to remove the No. 2 meter circuit plate.
![]() |
Disconnect the connector to remove the No. 5 meter circuit plate from the No. 2 meter circuit plate as shown in the illustration.
| 8. REMOVE NO. 2 COMBINATION METER CASE |
![]() |
Disengage the 2 guides to remove the No. 2 combination meter case.
| 9. REMOVE NO. 1 METER LENS |
![]() |
Disengage the 2 guides to remove the No. 1 meter lens.
| 10. REMOVE NO. 4 METER CIRCUIT PLATE |
![]() |
Disconnect the connector to remove the No. 4 meter circuit plate as shown in the illustration.
| 11. REMOVE NO. 3 METER CIRCUIT PLATE |
![]() |
Disengage the 2 guides to remove the No. 3 meter circuit plate.
| 12. REMOVE COMBINATION METER CASE |
![]() |
Disengage the 2 guides to remove the combination meter case.
| 13. REMOVE NO. 2 METER LENS |
![]() |
Disengage the 2 guides to remove the No. 2 meter lens.
| 14. REMOVE NO. 3 METER LENS |
![]() |
Disengage the 2 guides to remove the No. 3 meter lens.
| 15. REMOVE NO. 1 COMBINATION METER REFLECTOR |
![]() |
Disengage the clip and 9 guides, and remove the No. 1 combination meter reflector as shown in the illustration.
| 16. REMOVE NO. 3 COMBINATION METER CASE |