Home › Vehicle Interior › SEAT › SEAT HEATER SWITCH

SEAT HEATER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT SEAT HEATER SWITCH


    B177588E10
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    (Seat Heater Switch)

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    5 (IG) - 3 (LH)
    "L" switch off
    10 kΩ or higher
    5 (IG) - 3 (LH)
    "L" switch on
    Below 1 Ω
    4 (IG) - 6 (RH)
    "R" switch off
    10 kΩ or higher
    4 (IG) - 6 (RH)
    "R" switch on
    Below 1 Ω

    If the result is not as specified, replace the seat heater switch.

  1. Turn the seat heater switch on and check if the seat heater switch indicator comes on.

    OK:
    Connection
    Switch Condition
    Specified Condition
    Battery positive (+) → 4 (IG)
    Battery negative (-) → 2 (E)
    "L" switch on
    Comes on
    Battery positive (+) → 5 (IG)
    Battery negative (-) → 2 (E)
    "R" switch on
    Comes on

    If the result is not as specified, replace the seat heater switch.

  1. Check if the seat heater switch comes on.

    OK:
    Connection
    Switch Condition
    Specified Condition
    Battery positive (+) → 7 (ILL+)
    Battery negative (-) → 8 (ILL-)
    Always
    Comes on

    If the result is not as specified, replace the seat heater switch.