OUTER MIRROR SWITCH > INSPECTION |
| 1. INSPECT OUTER MIRROR SWITCH ASSEMBLY |
Check the mirror select switch and mirror surface adjust switch.
![]() |
Turn the mirror select switch to the L position.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 9 (VL) - 13 (B) 11 (M+) - 12 (E) | UP | Below 1 Ω |
| OFF | 10 kΩ or higher | |
| 9 (VL) - 12 (E) 11 (M+) - 13 (B) | DOWN | Below 1 Ω |
| OFF | 10 kΩ or higher | |
| 10 (HL) - 13 (B) 11 (M+) - 12 (E) | LEFT | Below 1 Ω |
| OFF | 10 kΩ or higher | |
| 10 (HL) - 12 (E) 11 (M+) - 13 (B) | RIGHT | Below 1 Ω |
| OFF | 10 kΩ or higher |
Turn the mirror select switch to the R position.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 8 (VR) - 13 (B) 11 (M+) - 12 (E) | UP | Below 1 Ω |
| OFF | 10 kΩ or higher | |
| 8 (VR) - 12 (E) 11 (M+) - 13 (B) | DOWN | Below 1 Ω |
| OFF | 10 kΩ or higher | |
| 7 (HR) - 13 (B) 11 (M+) - 12 (E) | LEFT | Below 1 Ω |
| OFF | 10 kΩ or higher | |
| 7 (HR) - 12 (E) 11 (M+) - 13 (B) | RIGHT | Below 1 Ω |
| OFF | 10 kΩ or higher |
| *1 | Mirror select switch |
| *2 | Mirror surface adjust switch |
| *a | Component without harness connected (Outer Mirror Switch Assembly) |
Check the mirror retract switch.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 15 (MF) - 12 (E) | Mirror retract switch retract position | Below 1 Ω |
| 14 (MR) - 13 (B) | Below 1 Ω | |
| 15 (MF) - 13 (B) | Mirror retract switch return position | Below 1 Ω |
| 14 (MR) - 12 (E) | Below 1 Ω |
| *1 | Mirror retract switch |
| *a | Component without harness connected (Outer Mirror Switch Assembly) |
Check the LED illuminates.
![]() |
Battery voltage to the outer mirror switch assembly and check that the LED illuminates.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 6 (ILL+) Battery negative (-) → Terminal 16 (ILL-) | LED illuminates |
| *a | Component without harness connected (Outer Mirror Switch Assembly) |