Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST PRE SUPPORT SWITCH

PARKING ASSIST PRE SUPPORT SWITCH > INSPECTION

for Preparation Click here



1. INSPECT PARKING ASSIST PRE SUPPORT SWITCH


    E159999E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 (E) - 6 (IG)
    Parking assist pre support switch pushed in
    Below 1 Ω
    Parking assist pre support switch not pushed
    10 kΩ or higher

    Text in Illustration 
    *1
    Component without harness connected
    (Parking Assist Pre Support Switch)
    If the result is not as specified, replace the parking assist pre support switch.