FRONT SEAT SIDE AIRBAG ASSEMBLY > REMOVAL |
| 1. PRECAUTION |
| 2. REMOVE REAR NO. 2 FLOOR BOARD |
![]() |
Disengage the 2 guides <A> as shown in the illustration.
Disengage the 3 guides <B> and remove the rear No. 2 floor board.
| 3. REMOVE REAR DECK FLOOR BOX |
Remove the rear deck floor box.
| 4. REMOVE REAR NO. 3 FLOOR BOARD |
![]() |
Disengage the 2 guides and remove the rear No. 3 floor board.
| 5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for Manual Seat) |
| 6. REMOVE FRONT SEAT HEADREST ASSEMBLY |
| 7. REMOVE OUTER SEAT TRACK COVER (for Manual Seat) |
![]() |
Lift up the seat track adjusting handle and move the seat to the foremost position.
Disengage the 2 claws and remove the outer seat track cover.
| 8. REMOVE OUTER SEAT TRACK COVER (for Power Seat) |
Operate the power seat switch knob and move the seat to the foremost position.
![]() |
Disengage the 2 claws and remove the outer seat track cover.
| 9. REMOVE INNER SEAT TRACK COVER (for Manual Seat) |
Disengage the claw.
![]() |
Separate the guide and remove the inner seat track cover.
| 10. REMOVE INNER SEAT TRACK COVER (for Power Seat) |
![]() |
Disengage the guide and claw and remove the inner seat track cover.
| 11. REMOVE FRONT SEAT ASSEMBLY (for Manual Seat) |
![]() |
Remove the 2 bolts on the rear side of the seat.
Lift up the seat track adjusting handle and move the seat to the rearmost position.
![]() |
Remove the 2 bolts on the front side of the seat.
Lift up the seat track adjusting handle and move the seat to the center position. Also, operate the reclining adjuster release handle and move the seatback to the upright position.
Disconnect the connectors under the seat.
Remove the seat.
| 12. REMOVE FRONT SEAT ASSEMBLY (for Power Seat) |
![]() |
Remove the 2 bolts on the rear side of the seat.
Operate the power seat switch knob and move the seat to the rearmost position.
![]() |
Remove the 2 bolts on the front side of the seat.
Operate the power seat switch knob and move the seat to the center position. Also, operate the power seat switch knob and move the seatback to the upright position.
Disconnect the cable from the negative (-) auxiliary battery terminal.
Disconnect the connectors under the seat.
Remove the front seat assembly.
| 13. DISCONNECT FRONT SEAT SIDE AIRBAG ASSEMBLY WIRE HARNESS |
![]() |
Disconnect the rubber band.
for LH Side:
![]() |
Disengage the claw and 3 clamps to separate the front seat side airbag assembly wire harness.
Disconnect the front seat side airbag assembly wire harness from the seat clamp.
for RH Side:
![]() |
Disengage the claw and 3 clamps to separate the front seat side airbag assembly wire harness.
Disconnect the front seat side airbag assembly wire harness from the seat clamp.
w/ Seat Heater System:
![]() |
Disconnect the seat heater wire harness connector and disengage the clamp.
Disengage the fastener and separate the front seat side airbag assembly wire harness.
![]() |
for Manual Seat:
Remove the 3 hog rings.
| 14. REMOVE FRONT SEATBACK COVER WITH PAD (for Manual Seat) |
![]() |
Remove the 3 hog rings.
![]() |
Disengage the 4 claws and remove the 2 front seat headrest supports.
![]() |
Turn back the separate type front seatback cover to remove the nut, and separate the bracket of the separate type front seatback cover RH.
Remove the separate type front seatback cover with pad from the front seat frame assembly with adjuster.
| 15. REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Power Seat) |
![]() |
remove the 2 hog rings.
![]() |
Remove the 3 hog rings.
![]() |
Pull out the lower part of 2 fasteners from the separate type front seatback cover as shown in the illustration.
![]() |
Open the 2 fasteners.
![]() |
Remove the 3 hog rings and disconnect the 2 fastening rubbers.
| *1 | Fastening Rubber |
![]() |
Disengage the 2 hooks.
![]() |
Turn back the separate type front seatback cover to remove the nut, and separate the bracket of the separate type front seatback cover.
![]() |
Disengage the 4 claws and remove the 2 front seat headrest supports.
Remove the separate type front seatback cover with pad from the separate type front seatback spring assembly.
| 16. REMOVE FRONT SEAT SIDE AIRBAG ASSEMBLY |
![]() |
Disengage the 2 clamps.
Remove the 2 nuts and the front seat side airbag assembly.