Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Navigation Receiver Type)

DTC    B1574    GVIF Disconnected (from Park Assist/Monitoring ECU to EMV/MM Integrated Device)

for Preparation Click here


DESCRIPTION

The navigation ECU sub-assembly and parking assist ECU are connected via video signal (digital) lines.
This DTC is stored when a video signal (digital) line is disconnected.

DTC Code
DTC Detection Condition
Trouble Area
B1574
Video signal (digital) is lost.
  1. Harness and connector
  2. Navigation ECU sub-assembly
  3. Parking assist ECU

WIRING DIAGRAM


E233648E02


INSPECTION PROCEDURE

1.REPLACE HARNESS AND CONNECTOR (NAVIGATION ECU SUB-ASSEMBLY - PARKING ASSIST ECU)
  1. Replace the harness and connector.

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.

    OK:
    No DTCs are output.



NG
Go to step 2
OK

END 

2.REPLACE PARKING ASSIST ECU
  1. Replace the parking assist ECU (Click here).

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.

    OK:
    No DTCs are output.



NG
REPLACE NAVIGATION ECU SUB-ASSEMBLY (Click here)
OK

END