Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR

OUTER REAR VIEW MIRROR > DISASSEMBLY

for Preparation Click here



1. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY


    E206795
  1. Disconnect the connector.

  1. Remove the 3 screws and side turn signal light assembly.



2. REMOVE OUTER MIRROR RETRACTOR


    B301123E01
  1. Cut the wire harness at the position shown in the illustration.
    Text in Illustration 
    *1
    Cut the wire harness here



    B301124
  1. Remove the gasket.



    B301125
  1. Disengage the 6 claws and guide and remove the lower cover.



    B301126
  1. Disengage the clamp and wire harness.



    B301127
  1. Disengage the wire harness, and using a T25 "TORX" socket wrench, remove the 3 screws.

  1. Remove the base from the housing.



    B301128
  1. Remove the 3 screws.



    B301129
  1. Disengage the clump.

  1. Disconnect the 2 connectors and remove the mirror actuator.



    B301130
  1. Remove the 2 screws.



    B301131
  1. Remove the frame sub-assembly as shown in the illustration.