Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR

OUTER REAR VIEW MIRROR > REASSEMBLY

for Preparation Click here



1. INSTALL OUTER MIRROR RETRACTOR


    B301139
  1. Pass a new wire harness through the motor and frame sub-assembly from the top as shown in the illustration.



    B301134
  1. Connect the connector to the frame sub-assembly.



    B301135
  1. Engage the guide as shown in the illustration to temporary install the frame sub-assembly to the housing.



    B301130
  1. Install the frame sub-assembly with the 2 screws.



    B301129
  1. Connect the 2 connectors.

  1. Engage the clamp.



    B301128
  1. Install the mirror actuator with the 3 screws.

    NOTICE:
    When installing the mirror actuator, check that the wire harness is not caught.



    B301127
  1. Using a T25 "TORX" socket wrench, install the base with 3 new screws.

    Torque:
    3.8 N*m{ 39 kgf*cm , 34 in.*lbf }

    NOTICE:
    When installing the base, check that the wire harness is not caught between the base and housing. Failure to do so may cause a short circuit.



    B301136E01
  1. Set the marking of the wire harness to the position shown in the illustration to engage it.
    Text in Illustration 
    *a
    Marking
    *b
    Position of the Clamp



    B301141
  1. Engage the guide and 6 claws and install the new lower cover.



    B301124
  1. Pass the wire harness through the new gasket to install it.



    B234744E04
  1. Install each connector to the adapter as shown in the illustration.
    Text in Illustration 
    *1
    Twisted wire harness



    B277974E01
  1. Wrap new vinyl tape as shown in the illustration.
    Area
    Measurement
    A
    40 mm (1.57 in.)



2. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY


    E206795
  1. Install the side turn signal light assembly with the 3 screws.

  1. Connect the connector.