Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › BATTERY COOLING DUCT (w/ Filter)

BATTERY COOLING DUCT (w/ Filter) > INSPECTION

for Preparation Click here



1. INSPECT NO. 1 HYBRID BATTERY INTAKE FILTER
  1. Inspect No. 1 hybrid battery intake filter.

    Standard:
    No clogs or damage.

    NOTICE:
    1. If the No. 1 hybrid battery intake filter is damaged, replace it with a new one.
    2. If the No. 1 hybrid battery intake filter is damaged, check for foreign matter in the battery cooling blower assembly. Clean or replace the battery cooling blower assembly if necessary.

  1. Clean the No. 1 hybrid battery intake filter.

    NOTICE:
    1. Clean the No. 1 hybrid battery intake filter with an air blow gun. Do not use water or any other liquid.
    2. Do not use a wire brush or any other type of brush as it may damage the No. 1 hybrid battery intake filter.
    3. To prevent removed foreign matter from entering the HV battery, make sure to remove the No. 1 hybrid battery intake filter when cleaning it.


    1. Using an air blow gun, clean the No. 1 hybrid battery intake filter.