DTC P0851-579 Park / Neutral Switch Input Circuit Low |
DTC P0852-580 Park / Neutral Switch Input Circuit High |
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
| P0851 | 579 | GND short in P position switch circuit |
|
| P0852 | 580 | Open or +B short in P position switch circuit |

| 1.INSPECT TRANSMISSION SHIFT MAIN SWITCH (P POSITION SWITCH) |
Disconnect connector b1 from the transmission shift main switch (P position switch).
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| b1-4 (S) - b1-2 (E) | Switch pressed | 680 Ω |
| b1-4 (S) - b1-2 (E) | Switch released | 4580 Ω |
| *1 | Component without harness connected (Transmission Shift Main Switch (P Position Switch)) |
Connect the transmission shift main switch (P position switch) connector.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (POWER MANAGEMENT CONTROL ECU - P POSITION SWITCH) |
Disconnect connector L5 from the power management control ECU.
Disconnect connector b1 from the transmission shift main switch (P position switch).
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| L5-16 (P1) - b1-4 (S) | Power switch off | Below 1 Ω |
| Tester Connection | Switch Condition | Specified Condition |
| L5-16 (P1) or b1-4 (S) - Body ground and other terminals | Power switch off | 10 kΩ or higher |
| *1 | Rear view of wire harness connector (to Power Management Control ECU) |
| *2 | Front view of wire harness connector (to Transmission Shift Main Switch (P Position Switch)) |
Connect the transmission shift main switch (P position switch) connector.
Connect the power management control ECU connector.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (P POSITION SWITCH - BODY GROUND) |
Disconnect connector b1 from the transmission shift main switch (P position switch).
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| b1-2 (E) - Body ground | Power switch off | Below 1 Ω |
| *1 | Front view of wire harness connector (to Transmission Shift Main Switch (P Position Switch)) |
Connect the transmission shift main switch (P position switch) connector.
|
| ||||
| OK | ||
| ||