Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM

DTC    P3000-388    HV Battery Malfunction

for Preparation Click here


DESCRIPTION

The power management control ECU alerts the driver and performs fail-safe control based on error signals received from the battery smart unit. This DTC is set when the SOC (state of charge) of the HV battery starts to drop as a result of leaving the shift lever in N, running out of fuel, or a malfunction in the hybrid control system.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P3000
388
Discharge inhibition control malfunction
  1. Fuel level
  2. HV battery

INSPECTION PROCEDURE

HINT:
  1. If the vehicle is stopped or parked with the shift lever in the N position for a long time, DTC P3000-388 may be set because the HV battery cannot be charged.
  2. When the engine cannot be started, DTC P3000-388 may be set because the HV battery cannot be charged.

1.CHECK DTC OUTPUT (HV)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

  1. Check if DTCs are output.

    Result:
    Result
    Proceed to
    P3000-388 or P3000-389 only is output.
    A
    DTCs other than P3000-388 and P3000-389 are also output.
    B

  1. Turn the power switch off.



B
GO TO DTC CHART (Click here)
A


2.CHECK DTC OUTPUT (ENGINE CONTROL SYSTEM)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

  1. Check if DTCs are output.

    Result:
    Result
    Proceed to
    NO DTCs are output.
    A
    DTCs are output.
    B

  1. Turn the power switch off.



B
GO TO DTC CHART (Click here)
A


3.CHECK AMOUNT OF GASOLINE
  1. Turn the power switch on (IG).

  1. Check the amount of fuel by referring to the fuel gauge in the meter.

    Result:
    Result
    Proceed to
    Proper amount of fuel is in the tank.
    A
    There is no fuel in the tank.
    B

HINT:
Add fuel until the low fuel level warning light turns off.

  1. Turn the power switch off.



B
REFUEL VEHICLE
A


4.CHECK ENGINE START
  1. Turn the power switch on (READY).

  1. Check if the engine starts.

    HINT:
    Depressing the accelerator pedal with the park (P) selected will cause the engine to start.

    Result:
    Result
    Proceed to
    The engine starts.
    A
    The engine does not start.
    B

  1. If the engine does not start, turn the power switch off.



B
REPLACE HV BATTERY (Click here)
A

LEAVE VEHICLE WITH PARK (P) SELECTED, AND CHARGE HV BATTERY BY IDLING UNTIL IDLING STOPS