FRONT SUSPENSION SYSTEM > GENERAL |
| OUTLINE |
A MacPherson strut type independent suspension is used.
Excellent driving stability and ride comfort have been achieved by optimizing the suspension geometry.
The steering gear box is mounted directly onto the suspension member, which improves steering initial response.

| *1 | Front Suspension Support Sub-assembly | *2 | Front Coil Spring |
| *3 | Front Shock Absorber Assembly | *4 | Front Lower No. 1 Suspension Arm |
| *5 | Front Stabilizer Bar | *6 | Suspension Member (Front Suspension Crossmember Sub-assembly) |
| SPECIFICATION |
| Tire Size | 195/65R15 | 215/45R17 | |
| Suspension Type | MacPherson Strut | ← | |
| Front Wheel Alignment (Unloaded Vehicle) | Tread | 1525 mm (60.0 in.) | 1515 mm (59.6 in.) |
| Caster | 5°53', 5°40'* | 5°50' | |
| Camber | -0°13', -0°07'* | -0°12' | |
| Toe-in | 2.0 mm (0.08 in.), 3.0 mm (0.12 in.)* | 2.0 mm (0.08 in.) | |
| King Pin Inclination | 12°16', 11°52'* | 12°10' | |
| MAIN FEATURES |
Optimized Caster
Optimum caster angle and trail value are featured to provide straight-line stability during low-speed to high-speed ranges and assist steering response during high speed.

| *a | Caster Angle | *b | Trail Value |
| *c | King Pin Axis | *d | Lower Ball Joint Fulcrum Point |
Optimized Camber
The front suspension uses negative camber to reduce the ground contact camber angle of the outer wheel at the time of turning (cornering) which is caused when the vehicle posture changes during cornering, thus offering excellent cornering performance.

| *a | Straight-line | *b | Cornering |
| *c | Negative Camber | - | - |
Optimized King Pin Offset
A small king pin offset is used and the moment which occurs around the king pin axis is made small in order to achieve excellent vehicle stability during braking. When force (F) is applied to the wheel during braking etc., (F) is applied at the tire center ground contact point (A) and the king pin offset radius (L). The power of (F) multiplied by (L) tries to turn the king pin axis. In this way, making the king pin offset smaller produces smaller moment of the king pin axis to provide excellent vehicle stability during braking.

| *a | Rear View | *b | Upper View |
| *c | King Pin Axis | *d | Tire Contact Center |
| *e | Tire Center Ground Contact Point (A) | *f | King Pin Offset (L) |
![]() | Force (F) | - | - |