GARAGE DOOR OPENER SYSTEM > DETAILS |
| FUNCTION |
The following table shows the mode and the indicator light operation.
| Mode | Function | Indicator Light |
| Transmission Mode | While the switch is being pressed, the garage door opener transmits the code that was previously registered. Even if the button is pressed continuously, the transmission stops after 20 seconds. | Flash → On (Rolling Code) ON (Except Rolling Code) |
| Learning Mode | When the button is pressed continuously for 20 seconds, the mode transfers to the learning mode in which a transmitter code can be registered. In this mode, a new transmitter code can be registered or an existing code can be overwritten. If no codes are registered within 90 seconds after transferring to the learning mode, the mode transfers to the low power mode. | Slow flashing (during learning mode) Quick flashing (registration completed) |
| All Delete Mode | When the 2 outside buttons are pressed simultaneously for 20 seconds, all the transmitter codes that are registered in the button are cleared. By releasing the buttons within 10 seconds after clearing the codes, the mode transfers to the learning mode. By keeping the buttons pressed longer than 10 seconds after clearing the codes, all the buttons will be registered with a code for operation verification. | Quick flashing (code clearing completed) |
| Low Power Mode | If the button remains pressed longer than 100 seconds, such as in the case in which the pressed button does not release it self, the mode transfers to the low power mode to reduce power consumption. | OFF |