LANE-KEEPING ASSIST SYSTEM > GENERAL



OUTLINE
  1. The lane-keeping assist system uses a lane recognition camera sensor to detect lane marker on the road surface, assists the driver's steering operation by using the Electric Power Steering (EPS), and activates the lane departure warning when needed.

  2. The lane-keeping assist system is controlled by the driving support ECU.


PRECAUTION

CAUTION:
  1. The lane-keeping assist system gives information to the driver and assists the driver's steering operations in accordance with road conditions and driving conditions. The driver is always required to correct the vehicle path while paying attention to road conditions and traffic and operate the steering wheel as their own responsibility.
  2. The lane-keeping assist system uses the lane recognition camera sensor, installed in the front, to detect lane markers. If the sensor does not detect sufficient lane markers, the system will not operate. In addition, if lane markers cannot be properly detected, unnecessary steering force may be applied or the buzzer may sound, so that the driver is required to operate the steering wheel manually.
  3. The lane-keeping assist system is a system that operates by detecting lane markers when the LKA main switch is on while driving at approximately 48 km/h (30 mph) or higher. However, depending on the road conditions or the driving conditions of the driver, the system may not be able to be activated or the system may be suspended.
  4. When the system detects a fault, the buzzer sounds and a warning message will appear to alert the driver and the system stops operating. However, normal driving can continue. Contact your Toyota dealer if any error alert is output repeatedly after turning the power switch on (IG) again.

  1. General Handling Precautions

    1. Turn the LKA main switch off under following conditions. The lane-keeping assist system may mistakenly detect lane markers and may not function appropriately.

      1. Light reflective tape is wrapped around poles for lane marking.
      2. Marks that may be mistakenly recognized as lane markers are on the road side structure.

    2. The lane-keeping assist system does not operate under following conditions.

      1. No lane marker on roads.
      2. Lane marker on only one side.

    3. The lane-keeping assist system may not be able to appropriately detect lane markers and may not function appropriately under the following conditions.

      1. Snow remains in ruts.
      2. Shadows are on road surfaces near parallel to lane markers or lane makers are in shadows.
      3. There are objects that may be mistakenly recognized as lane markers, such as guardrails, curbstones or reflection poles.
      4. Lane markers that are no longer in use or traces of asphalt repair remain.
      5. Branch roads or intersections.

    4. The lane-keeping assist system may not be able to appropriately detect lane markers and may not function appropriately or only operate intermittently under the conditions below.

      1. Unclear lane markers, yellow lane markers, botts' dots or cat's eyes are used as lane markers.
      2. Lane markers are not visible or hard to see due to problems such as clouds of sand.
      3. The road surface is a bright color, for example, concrete roads.
      4. The road surface reflects the bright sunlight.
      5. Brightness changes suddenly, for example, tunnel entrances or exits.
      6. Headlights of an oncoming vehicle or sunlight shine on the lane recognition camera sensor.
      7. Driving in bad weather such as rain or snow.
      8. Ice or snow on roads.
      9. Driving on wet road surfaces due to rain or on water puddles on roads.
      10. Distance between vehicles is extremely short.
      11. Vehicle bounce when driving on a rough or uneven road surface.
      12. Vehicle posture or vehicle height has been changed due to suspension modification to the genuine Toyota suspension.
      13. Any object that may reflect on the windshield glass is placed on the instrument panel.
      14. Windshield glass in front of the lane recognition camera sensor is dirty.

    5. Observe the following to properly operate the system. Otherwise, lane markers cannot be properly detected and the system may not operate or properly function.

      1. Do not place any obstacles in front of the lane recognition camera sensor.
      2. Set the inner mirror at an angle where it will not block the front area of the lane recognition camera sensor.
      3. Do not touch the camera lens.
      4. Do not remove the lane recognition camera sensor. The angle of the lane recognition camera sensor is precisely adjusted. If removed and installed, the lane recognition camera sensor angle must be adjusted.
      5. Do not apply excessive force to the lane recognition camera sensor.

    6. System performance cannot be sufficiently ensured under following conditions.

      1. Tires or wheels that are not genuine Toyota parts are used.
      2. Driving with strong cross winds.
      3. Driving on a road with a gradient.

    7. Do not activate the lane-keeping assist system under any of the following conditions.

      1. Winter tires, spare tires or tires with chains are being used.
      2. Driving with any parts related to vehicle driving performance having been changed from genuine Toyota parts.
      3. Driving with a trailer attached.

    8. Driver may not notice alert sounds if there are loud noises inside or surrounding the cabin.

    9. If the temperature inside the cabin rises, the system may not operate.