OCCUPANT CLASSIFICATION SYSTEM > DETAILS



FUNCTION OF MAIN COMPONENTS

Component
Function
Occupant Classification ECU
The occupant classification ECU judges whether the front passenger seat is occupied using signals from 4 front occupant classification sensors and front passenger seat belt buckle switch.
Front Occupant Classification Sensor LH/RH
The resistance values of these sensors, which vary in accordance with the distortion that acts on the brackets, are output to the occupant classification ECU.
Rear Occupant Classification Sensor LH/RH
Front Seat Inner Belt Assembly
Front Passenger Seat Belt Buckle Switch
The front passenger seat belt buckle switch detects if the front passenger seat belt is fastened.
Combination Meter Assembly
SRS Warning Light
The SRS warning light turns on up to alert the driver when the center airbag ECU assembly detects a malfunction in the airbag system.
Accessory Meter Assembly
AIRBAG ON/OFF Indicator Lights
  1. The AIRBAG ON/OFF indicator lights inform the driver whether the occupant classification ECU puts the front passenger airbag assembly and front passenger outer belt assembly RH into an active state or inactive state.
  2. If a malfunction occurs in the occupant classification system, the AIRBAG OFF indicator light and the SRS warning light come on.

OPERATING CONDITION
  1. The front passenger SRS items and indicator lights operate as follows according to the occupant classification.

    Item
    Occupant Classification
    Adult
    Child
    Unoccupied
    Failure
    Front Passenger Airbag Assembly
    X
    -
    -
    -
    Front Seat Side Airbag Assembly
    X
    X
    X
    X
    Front Seat Outer Belt Assembly for Front Passenger
    X
    X
    -
    X
    Curtain Shield Airbag Assembly for Front Passenger
    X
    X
    X
    -
    AIRBAG ON Indicator Light
    X
    -
    -
    X
    AIRBAG OFF Indicator Light
    -
    X
    -
    X

    1. X: Enabled (Light comes on)
    2. -: Disabled (Light goes off)


SYSTEM CONTROL


  1. Unoccupied judgment

    1. In the occupant classification system, the occupant classification ECU calculates the weight of the occupant based on signals from the occupant classification sensors.

    2. This system recognizes the occupant as a child if it detects a weight of less than 36 kg (79.37 lb), and disables the front passenger airbag assembly and front seat outer belt assembly RH.

    3. The occupant classification ECU contains criteria value "A" to judge whether the seat is being occupied by a child or a child seat in accordance with the signals from the 4 occupant classification sensors and front seat inner belt assembly, and criteria value "B" to judge whether the occupant is an adult or child (with child seat).

    4. The occupant classification ECU makes an unoccupied judgment when the judgment value is lower than criteria value "A" and the front passenger seat belt buckle switch is off.



    5. If the power switch is on in this state, the system performs an initial check, and does not illuminate the AIRBAG ON/OFF indicator lights. Then, the system prohibits the deployment of the front passenger airbag assembly and the front seat outer belt assembly RH, and does not blink the seat belt reminder light.


      Y103044E01



  2. Child seat or child judgment

    1. If the judgment value is lower than criteria value "B" and the front seat inner belt assembly (front passenger side seat belt buckle switch) is on, the occupant classification ECU judges that a child seat is installed.

    2. If the judgment value is higher than criteria value "A", but lower than criteria value "B", and the front seat inner belt assembly (front passenger side seat belt buckle switch) is off, the occupant classification ECU judges that the seat is being occupied by a child.



    3. When the power switch is on (IG) under these conditions, the system performs an initial check and illuminates the AIRBAG OFF indicator light to indicate that the front passenger airbag assembly have been deactivated.


      Y103045E01



  3. Adult judgment

    1. After the occupant classification ECU judges that a child seat is installed, the AIRBAG OFF indicator light does not go off unless the front seat inner belt assembly (front passenger side seat belt buckle switch) is turned OFF.

    2. When the judgment value is higher than criteria value "B" , the occupant classification ECU judges that the seat is occupied by an adult.



    3. If the power switch is turned on (IG) in this state, the system performs an initial check and illuminates the AIRBAG ON indicator light, indicating that the front passenger airbag assembly, passenger side knee airbag assembly, front seat side airbag assembly RH and front passenger outer belt assembly RH are active.


      Y103046E01

    4. After the occupant classification ECU judges that the occupant is an adult, and if the judgment value is determined as criteria value "B" or less according to occupant load movement, the ECU continues adult judgment for approximately 10 seconds before switching the child judgment.



  4. Initial check



    1. After the power switch is on (IG), the occupant classification ECU lights up the AIRBAG ON/OFF indicator lights via center airbag ECU assembly based on the timing chart below in order to check the indicator light circuits.


      Y103047E01


DIAGNOSIS
  1. If the occupant classification ECU detects a malfunction in the occupant classification system, the occupant classification ECU stores the malfunction data in memory. If the airbag ECU assembly detects a malfunction in the occupant classification ECU, the airbag ECU assembly illuminates the SRS warning light and AIRBAG OFF indicator light.

  2. The occupant classification ECU outputs 5-digit Diagnostic Trouble Codes (DTC) to the Techstream.

  3. The 5-digit DTC can be read after connecting the Techstream to the DLC3. For details, refer to the Repair Manual.