SFI SYSTEM > CHECK MODE PROCEDURE |
| CHECK MODE PROCEDURE |
Check and ensure the following conditions:
Battery voltage 11 V or more.
Throttle valve fully closed.
Push the P position switch.
A/C switch off.
Turn the power switch off.
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Utility / Check Mode.
Switch the ECM from normal mode to check mode.
![]() |
Make sure that the MIL flashes as shown in the illustration.
Turn the power switch on (READY).
Make sure that the MIL turns off.
Simulate that the conditions of the malfunction described by the customer.
Check DTCs and freeze frame data using the Techstream.