DTC P0630 VIN not Programmed or Mismatch - ECM / PCM |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0630 | When either of the following conditions is met (1 trip detection logic).
| ECM |
| Related DTCs | P0630: VIN not programmed |
| Required Sensors/Components (Main) | ECM |
| Required Sensors/Components (Related) | - |
| Frequency of Operation | Continuous |
| Duration | 0.325 seconds |
| MIL Operation | Immediately |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs are not present | None |
| Both of the following conditions are met | - |
| Auxiliary battery voltage | 8 V or more |
| Power switch | On (IG) |
| VIN code | Not programmed |
| VIN code | Programmed |
| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.READ DTC OUTPUT |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC P0630 is output | A |
| DTC P0630 and other DTCs are output | B |
|
| ||||
| A | |
| 2.INPUT VIN |
Input the VIN (Click here).
| NEXT | ||
| ||