Home › Vehicle Exterior › VEHICLE PROXIMITY NOTIFICATION SYSTEM › VEHICLE PROXIMITY NOTIFICATION SYSTEM

VEHICLE PROXIMITY NOTIFICATION SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedure to troubleshoot the vehicle proximity notification system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK

      NEXT


      3.INSPECT AUXILIARY BATTERY VOLTAGE
      1. Measure the auxiliary battery voltage with the power switch off.

        Standard Voltage:
        11 to 14 V

        If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.


      NEXT


      4.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
      1. Using the Techstream to check if the CAN communication system is functioning normally.

        Result:
        Result
        Proceed to
        CAN DTC is not output
        A
        CAN DTC is output
        B



      B.
      GO TO CAN COMMUNICATION SYSTEM (Click here)
      A


      5.CHECK FUNCTION OF LIGHTING SYSTEM (EXT)
      1. Check whether the lighting system is functioning normally (Click here).

        Result:
        Result
        Proceed to
        Lighting system is functioning normally
        A
        Lighting system is not functioning normally
        B



      B.
      GO TO LIGHTING SYSTEM (Click here)
      A


      6.CHECK METER / GAUGE SYSTEM*
      1. Using the GTS to check if the meter/gauge system is functioning normally.

        HINT:
        If the vehicle approaching speaker controller mistakenly receives a vehicle speed signal, communication between the vehicle and the GTS fails. Be sure to check "Vehicle Speed Meter" displayed on the Data List to make sure that the vehicle speed is not abnormal.

        Result:
        Result
        Proceed to
        No vehicle speed signal is mistakenly received
        A
        A vehicle speed signal is mistakenly received
        B



      B.
      GO TO METER / GAUGE SYSTEM (Click here)
      A


      7.CHECK HYBRID CONTROL SYSTEM
      1. Check whether the hybrid control system is functioning normally (Click here).

        Result:
        Result
        Proceed to
        Hybrid control system is functioning normally
        A
        Hybrid control system is not functioning normally
        B



      B.
      GO TO HYBRID CONTROL SYSTEM (Click here)
      A


      8.CHECK FOR DTC*
      1. Check for DTCs (Click here).

      2. Clear the DTCs (Click here).

      3. Recheck for DTCs (Click here).

        Result:
        Result
        Proceed to
        DTCs are output
        A
        DTCs are not output
        B



      B.
      GO TO STEP DIAGNOSTIC TROUBLE CODE CHART (Click here)
      A


      9.PROBLEM SYMPTOMS TABLE

        Result:
        Result
        Proceed to
        Fault is not listed in Problem Symptoms Table.
        A
        Fault is listed in Problem Symptoms Table.
        B



      B.
      GO TO PROBLEM SYMPTOMS TABLE (Click here)
      A


      10.OVERALL ANALYSIS AND TROUBLESHOOTING
      1. Data List / Active Test (Click here)

      2. Terminals of ECU (Click here)

      3. Inspection


      NEXT


      11.REPAIR OR REPLACE

        NEXT


        12.CONFIRMATION TEST

          NEXT

          END