Home › Engine / Hybrid System › 2ZR-FXE COOLING › THERMOSTAT

THERMOSTAT > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER


2. REMOVE INLET AIR CLEANER ASSEMBLY


    A269507
  1. Remove the 2 bolts and inlet air cleaner assembly.



3. REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE SUB-ASSEMBLY


    A213046
  1. Remove the engine oil level dipstick.

  1. Disconnect the clamp and remove the 2 bolts and engine oil level dipstick guide.

  1. Remove the O-ring from the engine oil level dipstick guide.



4. DRAIN ENGINE COOLANT (for Engine)

NOTICE:
Do not remove the reservoir tank cap and radiator drain cock plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.



  1. Loosen the radiator drain cock plug and drain the coolant.


    A251110E01


    Text in Illustration 
    *1
    Reservoir Tank Cap
    *2
    Radiator Drain Cock Plug

    HINT:
    Collect the coolant in a container and dispose of it according to the local regulations.



5. REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY


    A216072E01
  1. Disconnect the No. 2 radiator hose and No. 3 water by-pass hose.
    Text in Illustration 
    *1
    No. 2 Radiator Hose
    *2
    No. 3 Water By-pass Hose

    NOTICE:
    1. Do not apply force to the water inlet with thermostat sub-assembly when disconnecting the No. 3 water by-pass hose.
    2. Do not damage the water inlet with thermostat sub-assembly.

    HINT:
    When disconnecting the No. 3 water by-pass hose, pinch the hose clamp, rotate the hose and pull it straight off the pipe.



    A216071
  1. Remove the 2 nuts, bolt and water inlet with thermostat sub-assembly.



    A216666
  1. Remove the gasket from the water inlet with thermostat sub-assembly.