Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM

WIPER AND WASHER SYSTEM > Headlight Signal Circuit

for Preparation Click here


DESCRIPTION

The headlight cleaner control relay detects the low beam headlights status.

WIRING DIAGRAM


E182121E03


INSPECTION PROCEDURE

NOTICE:
First check that the low beam headlights operate normally.

1.CHECK HARNESS AND CONNECTOR (INTEGRATION RELAY - HEADLIGHT CLEANER CONTROL RELAY)


    E144468E21
  1. Disconnect the A44 headlight cleaner control relay connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    A44-1 (HDLO) - Body ground
    Light control switch in head position
    Below 1 V
    Light control switch off
    11 to 14 V

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Headlight Cleaner Control Relay)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)