STEERING COLUMN ASSEMBLY > DISASSEMBLY |
| 1. REMOVE POWER STEERING MOTOR ASSEMBLY (for Brush Type Motor) |
Remove the each tape and clamp from the power steering motor assembly and wire harness.
![]() |
Remove the 2 bolts and power steering motor assembly from the electric power steering column sub-assembly.
| 2. REMOVE POWER STEERING MOTOR ASSEMBLY (for Brushless Type Motor) |
Remove the each tape and clamp from the power steering motor assembly and wire harness.
![]() |
Using a screwdriver, disengage the claw to remove the torque sensor harness connector.
![]() |
Remove the 2 bolts and power steering motor assembly from the electric power steering column sub-assembly.
![]() |
Remove the electric power steering motor shaft spacer from the electric power steering column sub-assembly.
![]() |
Remove the electric power steering motor shaft damper from the electric power steering column sub-assembly.