STEERING PAD > INSTALLATION |
| 1. INSTALL STEERING PAD |
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
![]() |
Connect the 2 airbag connectors to the steering pad.
Push in the 2 locks to install the 2 airbag connectors.
Connect the horn connector to the steering pad.
![]() |
Push the steering pad to engage the 2 pins.
| 2. INSTALL LOWER NO. 3 STEERING WHEEL COVER |
![]() |
Engage the claw to install the lower No. 3 steering wheel cover.
| 3. INSTALL LOWER NO. 2 STEERING WHEEL COVER |
![]() |
Engage the claw to install the lower No. 2 steering wheel cover.
| 4. CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL |
| 5. INSTALL REAR NO. 3 FLOOR BOARD |
![]() |
Engage the 2 guides to install the rear No. 3 floor board.
| 6. INSTALL REAR DECK FLOOR BOX |
Install the rear deck floor box.
| 7. INSTALL REAR NO. 2 FLOOR BOARD (for Separate Type) |
![]() |
Engage the 3 guides <A>.
Engage the 2 guides <B> and install the rear No. 2 floor board as shown in the illustration.
| 8. INSPECT STEERING PAD |
![]() |
Visually check for defects with the steering pad installed on the vehicle.
The defects are as follows:
Make sure that the horn sounds.
| 9. PERFORM DIAGNOSTIC SYSTEM CHECK |
Perform a diagnostic system check (Click here).
| 10. INSPECT SRS WARNING LIGHT |
Inspect the SRS warning light (Click here).