SPIRAL CABLE > INSTALLATION |
| 1. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY |
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Check that the front wheels are facing straight ahead.
Set the turn signal switch to the neutral position.
![]() |
Install the spiral cable with sensor sub-assembly with the 3 claws.
Connect the connectors to the spiral cable with sensor sub-assembly.
| 2. INSTALL UPPER STEERING COLUMN COVER |
![]() |
Engage the 2 claws and 2 pins to install the upper steering column cover.
| 3. INSTALL LOWER STEERING COLUMN COVER |
![]() |
Engage the 2 claws to install the lower steering column cover.
![]() |
Engage the 4 claws.
![]() |
Engage the 2 claws.
| 4. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD |
| 5. ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY |
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
![]() |
Rotate the spiral cable counterclockwise slowly by hand until it stops.
![]() |
Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.
| *1 | Alignment Mark |
| 6. INSTALL STEERING WHEEL ASSEMBLY |