Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SIDE AIRBAG SENSOR

SIDE AIRBAG SENSOR > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below is for the LH side.



1. PRECAUTION

CAUTION:
Be sure to read Precaution thoroughly before servicing (Click here).



2. REMOVE REAR NO. 2 FLOOR BOARD (for Separate Type)


    B227787E01
  1. Disengage the 2 guides <A> as shown in the illustration.

  1. Disengage the 3 guides <B> and remove the rear No. 2 floor board.



3. REMOVE REAR DECK FLOOR BOX
  1. Remove the rear deck floor box.



4. REMOVE REAR NO. 3 FLOOR BOARD


    B227791
  1. Disengage the 2 guides and remove the rear No. 3 floor board.



5. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



6. REMOVE FRONT DOOR SCUFF PLATE


    B227761
  1. Disengage the 10 claws and remove the front door scuff plate LH.



7. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP


8. REMOVE REAR DOOR SCUFF PLATE


    B227766
  1. Disengage the 7 claws and remove the rear door scuff plate LH.



9. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP


10. REMOVE CENTER PILLAR LOWER GARNISH


    B227782
  1. Disengage the 2 claws and 2 clips, and remove the center pillar lower garnish LH.



11. REMOVE SIDE AIRBAG SENSOR
  1. Check that the power switch is off.

  1. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



    B231031
  1. Disconnect the connector.

    NOTICE:
    When disconnecting any airbag connector, take care not to damage the airbag wire harness.




    1. Push and hold the white housing lock, and slide the yellow outer connector locking sleeve.


      C195226E03


      Text in Illustration 
      *1
      Housing Lock
      *2
      Outer Connector Locking Sleeve

    2. Push and hold the white housing lock again, and slide the yellow outer connector locking sleeve to disconnect the connector.



    B231032
  1. Remove the bolt and side airbag sensor.

    NOTICE:
    Loosen the bolt while holding the side airbag sensor because the side airbag sensor pin (stopper) is easily damaged.