Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › KNEE AIRBAG ASSEMBLY

KNEE AIRBAG ASSEMBLY > ON-VEHICLE INSPECTION

for Preparation Click here


CAUTION:
Be sure to follow the correct removal and installation procedures of the driver side knee airbag assembly.



1. INSPECT DRIVER SIDE KNEE AIRBAG ASSEMBLY (for Vehicle not Involved in Collision)
  1. Perform a diagnostic system check (Click here).

  1. Visually check for defects with the driver side knee airbag assembly installed on the vehicle.

    1. The defects are as follows:

      1. Cuts on the driver side knee airbag assembly
      2. Small cracks on the driver side knee airbag assembly
      3. Significant discoloration on the driver side knee airbag assembly

      OK:
      No defects are found.

      HINT:
      If any of the defects is found, replace the driver side knee airbag assembly with a new one.



2. INSPECT DRIVER SIDE KNEE AIRBAG ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)
  1. Perform a diagnostic system check (Click here).

  1. Visually check for defects with the driver side knee airbag assembly removed from the vehicle.

    1. The defects are as follows:

      1. Cuts on the driver side knee airbag assembly
      2. Small cracks on the driver side knee airbag assembly
      3. Significant discoloration on the driver side knee airbag assembly
      4. Cracks or other damage to the connector
      5. Deformation or cracks on the instrument panel or instrument panel reinforcement

      OK:
      No defects are found.

      HINT:
      If any of the defects is found, replace the driver side knee airbag assembly, instrument panel or instrument panel reinforcement with a new one.