FRONT PASSENGER AIRBAG ASSEMBLY > INSTALLATION |
| 1. INSTALL NO. 3 INSTRUMENT PANEL WIRE |
![]() |
Connect the 2 airbag connectors to the front passenger airbag assembly.
Push in the 2 locks to install the 2 airbag connectors.
Connect the No. 3 instrument panel wire to the front passenger airbag assembly clamp.
Engage the clamp to install the No. 3 instrument panel wire to the front passenger airbag assembly.
| 2. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY |
![]() |
Engage the 3 hooks.
![]() |
Push the front passenger airbag assembly to engage the 3 hooks.
![]() |
Install the 2 screws to install the front passenger airbag assembly.
Install the 2 clamps to the front passenger airbag assembly.
| 3. INSTALL UPPER INSTRUMENT PANEL ASSEMBLY |
When using a new upper instrument panel sub-assembly:
Immediately before installing the upper instrument panel assembly, twist and cut off the portions shown in the illustration.

Engage the 5 claws as shown in the illustration.
Engage the 2 claws and 4 clips, and install the upper instrument panel assembly as shown in the illustration.

Install the 2 bolts <B>.
Install the 2 passenger airbag bolts <A>.
| *1 | Passenger Airbag Bolt <A> | *2 | Bolt <B> |
Engage the 2 clamps.
Connect each connector.
| 4. CONNECT NO. 3 INSTRUMENT PANEL WIRE |
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
![]() |
Connect the connector.
| 5. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH |
| 6. PERFORM DIAGNOSTIC SYSTEM CHECK |
Perform a diagnostic system check (Click here).