CURTAIN SHIELD AIRBAG ASSEMBLY > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL |
| 3. REMOVE ROOF HEADLINING ASSEMBLY |
| 4. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY |
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
![]() |
Using a screwdriver with the tip wrapped with protective tape, release the airbag connector lock and disconnect the curtain shield airbag connector.
| *1 | Protective Tape |
Remove the 5 bolts.

Remove the 4 clips.

![]() |
Using a clip remover, remove the 4 pins.
| *1 | Pin |
| *2 | Clip |
| *3 | Airbag |
| *4 | Body |
![]() |
Using a screwdriver with the tip wrapped with protective tape, separate the 4 clips and curtain shield airbag assembly from the body as shown in the illustration.
| *1 | Clip |
| *2 | Airbag |
| *3 | Body |
| *4 | Spacer |
Disengage the 5 hooks to remove the curtain shield airbag assembly.

Remove the 4 clips and 4 spacers from the curtain shield airbag assembly.